History of CSV/SubrefPositionMeasurementSBRx (No. 5)

• History
• View the source.
• CSV/SubrefPositionMeasurementSBRx has been deleted.
  • 1 (2016-07-22 (Fri) 17:56:24)
  • 2 (2016-07-22 (Fri) 18:24:45)
  • 3 (2016-07-25 (Mon) 17:28:18)
  • 4 (2016-07-26 (Tue) 12:39:00)
  • 5 (2016-08-16 (Tue) 13:16:48)
  • 6 (2016-08-16 (Tue) 23:49:50)
  • 7 (2016-09-02 (Fri) 11:56:44)
  • 8 (2016-09-02 (Fri) 17:25:32)
  • 9 (2016-09-05 (Mon) 22:37:30)

Commissioning and Science Verification

Subref position offsets for single-beam receivers > Measurement†

Revision history

• 2016-08-01 - created by Kamazaki,T.

Table of contents

• Subref position offsets for single-beam receivers > Measurement
  • Measurement

Measurement†

1. Start COSMOS3 and tune the receiver to be used
   • Check Aspirin is in the WIND ON mode
2. Login to COSMOS3 manager GUI with Group=asteXX (e.g. aste16) and Project=sbrfXX (e.g. sbrf16)
3. Run qlookc and turn on auto-pointing on the GUI
4. Adjust pointing (preferable, but can skip) using either of the following observation tables
    

   Saturn	DASH345	stx5d3.start
   	BAND8	stx5b8.start

    
   • Auto-pointing is available toward bright planets
   • Turn on auto-pointing on qlookc, when you use it
5. Make sure the following points
    

   Aspirin	WIND ON
   Autop	on

    
6. Run either of the following observation tables according to a planet and a receiver
    

   Saturn	DASH345	stsbd3.list
   	BAND8	stsbb8.list

    

1. Initial pointing
2. Subref z-axis focus
3. Start measurements