History of Open-use_program/aobs (No. 2)

• History
• View the diff.
• View the diff current.
• View the source.
• Go to Open-use_program/aobs.
  • 1 (2020-10-17 (Sat) 07:33:20)
  • 2 (2020-10-17 (Sat) 07:54:31)
  • 3 (2020-10-25 (Sun) 13:14:09)
  • 4 (2021-02-13 (Sat) 06:21:20)
  • 5 (2021-05-29 (Sat) 08:56:47)
  • 6 (2021-06-03 (Thu) 04:48:55)
  • 7 (2023-07-06 (Thu) 00:36:21)

ASTE Wiki

How to make "Observation Table"†

Before observations with the ASTE 10m telescope, you must prepare "Observation Table" which consists of three subtables ("Source Table", "Scan Table", and "Device Table") and send it to the workstation which controls the ASTE 10m telescope system. You can make these subtables and send "Observe Table" to the workstation by using a software "Obstable". This manual explain how to use "Obstable" and about the parameters which you have to enter.

Contents

1. Preparation
   • You have to get an observation account for each new proposal before you make "Observation Table".
   • ASTE will inform you of the account beforehand.
   • Even if you have already gotten the accounts for past observations, you cannot use them for your new proposals.
2. How to use Aobs
   • Startup Aobs
   • Preparation of Source Table, Scan Table, and Device Table
   • Preparation of Observe Table
   • Basic operation
3. Parameters of Source Table
   • (RA,DEC) or (L,B)
   • (Az,El)
   • Solar object
4. Parameters of Scan Table
   • Line observation
   • Continuum observation (not opened to the open-use program)
5. Parameters of Device Table
   • Line observation (MAC - decommissioned)
   • Line observation (WHSF)
   • Continuum observation (not opened to the open-use program)