Since the failure of DDS boards last year we have too messy cabling around NIM rack.
I started to prepare a box to enclose all mixers and PLL monitor boxes.
I picked a 2U box and fitted a small aluminium plate to host these components.
The BNC mixers are now properly fixed.
For the SMA mixers I would like to use custom length SMA cables.
I would like to use LEMO feedthrough on the front panel but up to now I can't find the proper washers...
7 mixers and their low pass filters, 2 DC blocks and 1 splitter has been fixed to the aluminium frame.
I also found a board with LEMO 'i-style' feedthrough so I'll take them from this board for the front panels.
Next step is to prepare front panel and several short length sma cables.