Member: R. Takahashi, N. Ohishi, K. Doi
June 11
1) Clean the floor of clean booth.
2) Open the chamber.
3) Adjust the height of breadboard. The height was set to 490mm +/- 1mm from the base plate.
4) Measure the position of the breadboard by the straight edge and the pendulum. The position was deviated by -1.0mm, -1.75mm from the center of the chamber.
June 12
1) Measure the rotation of the breadboard by the straight edge and the pendulum. The position of support bolt was on the Y line within +/- 0.5mm.
2) Pick up some parts from the bottom of chamber. We found M10 long bolt, Al foil, I-bolt, and CCP base.
3) Close the chamber.